Introduction
使用說明

1. Locating the creasing position, and then put the aluminum block up to the corresponding calibration place.
   確定壓痕位置，將鋁定位塊放于相應刻度處。

2. At the same time put the paper close to the positioning aluminum block and left aluminum pressing piece, and press the handle, the crease can be made out.
   將紙張同時靠緊鋁定位塊及左側鋁鍵條，下壓手柄，即可壓出凹痕。

3. This machine can change the bottom template. As the optional part, we can offer the bottom template which can press the crease under. If you have any other requirement, please phone or email to us, we will make the corresponding crease template as you need.
   本機可更換底模，從而壓出不同的凹痕。作為可選件，我公司提供可壓下面凹痕的底模。如對凹痕有其它要求，請致電本公司，可特製相應痕模。

4. Way to change bottom template: screw the four big bolts at the both sides of the bottom hull, and replace the new bottom template, the screw the bolts, and then screw tightly the bolts.
   底模的更換方法：擰開底殼兩側的四個大螺絲，換下底模，擰上螺絲，調整底模凹槽與到完全吻合，再擰緊螺絲。

5. If the creases are deep on one side and shallow on the other side, the inner plastic flake must be adjusted or changed, Open the back hull, go around the plastic flake, and adjust the height of the knife. If the plastic flake is seriously worn, it should be changed
   如出現壓痕一側淺一側深，則須調整或更換內部的塑料片。將後蓋卸開，旋轉塑料片，調整刀的高低。如塑料片磨損嚴重，則需更換。
6. If the paper is creased split when pressing the crease, the bottom template or the knife should be adjusted until they completely suit to each other
   壓痕時，如出現壓裂紙張的現象，則須調整底模與刀的吻合程度。

PRICE: RM 400.00